SKU:R1X3P
Process Station Gas Cylinder Rack with Plate (1x3)
Process Station Gas Cylinder Rack with Plate (1x3)
Couldn't load pickup availability
Gas cylinder rack is fabricated out of tube steel 2” x 2” and 11 ga. thick plate. It can accommodate cylinders up to 12” dia. and can hold 3 cylinders. The cylinders are secured using polypropylene straps and additional chains can be added if required. The 12” high horizontal panel at top can be used to mount cylinder control valves, manifolds and/or flow meter as required.
Color:
Gray color readily available in stock, other custom colors offered, please call to check availability.
Lead time:
Product is made-to-order and ships 5–10 business days after the order date.
Specifications
- Cylinder capacity: 3
- Cylinder diameters supported: Up to 12"
- Built from 11 gauge and heavier plate fully welded
- Powder coated finish
- Edges protected with steel reinforced vinyl edge guarding
- Two 1.5" Polypropylene straps and cinch buckle included
- Elevated panel (14" by 12") allows for mounting of cylinder controls, cross-over
- devices, etc.
- Chain sets (optional) can be added for additional support
- Dimensions: 40" wide x 12" deep x 72" high
- Product Weight: 80 lbs.
- Made in the USA
Safety & Compliance
Safety & Compliance
Karan and Associates gas cylinder storage and restraint products are designed to help support compliance with applicable safety requirements when properly selected, installed, and used.
Applicable standards and guidance may include OSHA 29 CFR 1910.101 (General Industry), OSHA 29 CFR 1926.350 (Construction), NFPA 1, NFPA 55, and CGA P-1. Properly installed stationary products may also support applicable USGS high seismic hazard zone requirements.
Compliance depends on the complete installation and how cylinders are stored, secured, handled, and used.
Learn more about Gas Cylinder Safety
Installation
Installation
Pick a location free from vehicle traffic, excessive heat and electrical circuits. It should be a dry and well-ventilated area.
Secure rack to the ground/floor using the appropriate hardware for the material. Typical size bolt is 1/2" by 5 1/2" size. Anchor bolts are not included. Each rack has pre-drilled 0.531" holes in each arm for mounting to ground.
It is recommended that a site survey be completed by the authority having jurisdiction to determine the suitability of the barricade racks at that location and to confirm all local regulations are being followed.
Custom Options
Custom Options
Didn’t quite find what you were looking for? You need a different color or different dimension?
We’re here to help. Please call us at 909-401-2914 or send us an e-mail to sales@karanandassociates.com.
